Birmingham Water Heater Odor Repair

Are you having a dilemma with smelly odors originating from the water coming from your water heater? It could happen from time to time for a couple various reasons. Here is what Water Heater Repair Birmingham advises to do to make sure your water smells considerably better and to remove any terrible taste fast.

Causes for Birmingham Water Heater Smells?

Bacteria entering into the water system is the most common explanation ones water in the home could have smells. If you home uses well water or cities that use wells for the water source, will increase the chance of this happening.

With a water heater temperature setting of 140 degrees or higher will help in reducing the growth of bacteria inside of the water storage tank.

Ways to Eliminate Stinky Water Odors

The following directions describe how to use chlorine bleach to wash a water heater.

The electric or gas leading to the water heater tank needs to first be turned off.

Next, the cold water supply off that leads to the tank needs to be shut off.

Open the hot water faucet of the kitchen sink to enable air to get in the tank.

With a a garden hose hooked up to the storage tank drain valve, drain the water inside the water heater.

Then shut the drain valve once it is empty.

The next step is adding the bleach.
If the hose for the cold water travelling within the storage tank is a flexible hose, unscrew it from the tank. Otherwise, one will likely need to take off the pressure relief valve, which is more involved. For electric water heaters, one of the elements can be removed.

Use a funnel to put bleach into the opening.
Add 5 ounces of bleach for each gallon of the tank capability.
So if you have a 50 gallon water heater, you will need 250 ounces of bleach, or close to 2 gallons.

Reinstall the water line or pressure relief valve.

Fill the tank back up with water again.

Shut the hot water faucet of the kitchen faucet as quickly as all the air is out of the line.

Run all the hot water appliances till the odor of bleach is noticeable. We want to get rid of the microorganisms that are located in the water lines also, not just inside of the water heater.

Keep the water in the tank and water lines without using and hot water for a couple of hours.

Empty the storage tank again and refill it. This time allow it to stay for at least 30 minutes and just as before drain it.

Fill the tank back up. Open all the hot water fixtures and let them run until the scent of bleach is gone.

For gas water heaters, relight the water heater pilot light. For electric water heaters, turn the electricity on once more.

In addition, by replacing the anode rods, or simply the type used can do the trick as the following video shows:

Additionally, by replacing the anode rods, or perhaps the type employed can work as the next video shows:

Odors from Birmingham Water Heater

What the Experts Say

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Soquel Creek Water District

How is hydrogen sulfide gas produced in a water heater?

A water heater can provide an ideal environment for the conversion of sulfate to hydrogen sulfide gas. The water heater can produce hydrogen sulfide gas in two ways – creating a warm environment where sulfur bacteria can live, and sustaining a reaction between sulfate in the water and the water heater anode.  Read more…

Minnesota Department of Health

Check out some of our other water heater tips in our blog